CNC Router Online Help and Troubleshooting Guide
 Position Error Scenario: You are repeatedly getting the following message box: 
Problem: The machine is unable to travel to the position that has been requested of it. Solution: There are a few pieces of information necessary to determine the cause of this issue.
If the machine does not move in any of the axes, you should Verify power to the machine
• Verify power to the machine • Ensure feedback in setup • Are you attempting to move the system at a speed higher than possible for the Controller box? • Is the machine smashing into the End of travel? • Is there a blockage in the axis that is causing a Frozen axis? • Check for Amplifier status. • If the symptom of the position error is that it only occurrs in a specific location on the machine, you can test for Axis tightness. This is very uncommon. |
Copyright ©
Techno CNC Systems, LLC. All rights reserved.