Techno CNC Systems

   CNC Router
Online Help and Troubleshooting Guide
Power receptacle:

The power receptacle is located at the back of the box.

It will have the power cable running into it.
    To check the fuses:
  • Lock out power
  • On receptacles made after 2007, there are two tabs on the side. Press them inwards to extract the fuse holder.
  • On some older units, you may need to use a small screwdriver at the bottom of the fuse holder to pop it out.
  • Use a Multimeter to verify the fuses. Sometimes fuses that look good are burned.

Copyright ©  Techno CNC Systems, LLC. All rights reserved.