Techno CNC Systems


You receive an error indicating that the start button is being pressed on startup


The Start and Pause buttons on your start stop box are not working properly, but in diagnostics, they behave properly.


The Start Stop Box mode is not set properly.


  • Click Setup
  • Click Advanced
  • Click Touchpad and Remote
  • Click the button for "Test Remote"
  • You will be prompted to press the start, then the pause buttons.

This will set your start stop box mode properly. On most common machines, the proper mode number is 1 or 5.

If your start stop box continues to work improperly, ensure proper start stop box operation by going through the procedure in the SSB Diagnostics page.

Copyright ©  Techno CNC Systems, LLC. All rights reserved.